Quote:
|
Originally Posted by marvins_dad
Great How-To!!!
Thanks manoverboard987!  |
You're very welcome. Just doin my part to add to the org's wealth of knowledge.
Quote:
|
Originally Posted by GGKauten
Did you get that from eBay? I am just wondering because I was thinking about getting this for my NB but after seeing how chinsy the light looks on the back side (raw circuit board chillin across the bulb backings) I might reconsider.
|
Yes, it came from eBay.
Here's the link. Over the 3 weeks between recieving it and installing it, it's been shipped twice, gone on a 250 mile road trip, been dropped thrice, and had calculus books fall on it. Conclusion: It's a pretty tough little light, bare circuit board or not. Plus, you can always put a coating or even electrical tape over the back if you're worried about it. Personally, looking at how clean and un-leaky my turunk lid had been (under there is some of the brightest paint you'll ever see), I had no problem leaving the circuit board exposed.
Quote:
|
Originally Posted by Asurroca
Same here. I want one of these
Great how-to, by the way. I'll have to refer to it when I get my hands on a set of these clear brake lights.
|
Just follow the link. And thanks for the props.
