Step Five: [VHL DIY 025 thru 032] Remove the upper rear window and seat belt and column trim. It is possible to get the headliner out at this point but I do not recommend it as you have to bend the seat belt column trim to much, which damages it; I know I speak from experience.
To get the upper rear window down remove the lone screw noted in pic 025; however you should wait until you get the seat belt trim disconnected or you will bend the plastic to far. To remove the hand strap, pop off the cover plate 026 and remove the one screw 027 and the three remaining screws noted in pic 028. Next flip up the seat belt cover plate and remove the seat belt bracket bolt noted in pic 032. Now remove the seat belt column trim and the upper window trim.
For model years '99 and up you have a sun glasses case on the drivers side [033 and 034] and a grab handle [035] on the passenger side; each is held on by two screws; do not loose the screws. Using the wrong longer screws will result in putting holes in your roof. To access the screws you must open the plastic cover/cap; place the tip of a small screw driver in the small hole [033] pry toward you and it will pop open.