There is a black dust cap on the black spindle piece that is at a right angle to the emblem. If the black dust cap is not there, it is inside the other piece that is on your car. Use tweezers or needle nose pliers to retrieve it. Note its location so it can go back in the same manner. Remove the dust cap. Using a pair of needle nose pliers, remove the “C” clip that is holding the spring on to the spindle. Be careful to not let the spring go flying. There is also a washer and an “O” ring underneath the spring. Lift the trim ring off of the spindle of the old emblem and place onto the new emblem’s spindle. Put the spring onto the spindle.
Depress the spring to below the lip where the “C” clip will go. Put the “C” clip on the spindle of the new emblem. Replace the dust cap correctly.
|